Rydder litt plass i shacken her og har ett par rigger til salgs.
Forøvrig, vil jeg i tillegg til det etablerte annonsetilbudet for amatør-utstyr her i Norge oppfordre andre i markedet for kjøp & salg til å bruke Classified-seksjonen til LA Contest Club
For når admin har godkjent annonsen blir den uten “delay” postet slik at hele webben kan lese den.
I’v just tested a new Tayloe Quadrature Product Detector and Preamp made by LA6NCA Helge.
As the video show. I have down converted the 1st IF from the FT-1000d to somewhere around 460KHz and fed the signal to the product detector.
I have been so fortunate to be given permission to post these documents.
I think they are very helpful for any trying to understand the ft-1000(d)
conversion route.Thanks to to the author Scott K9MA for making this available for the ham community.
Opened up the ft-1000d today and discovered that the famous w8ji noise blanker modification was missing. Well, no need to dwell. Fired up the soldering iron, picked up three 1n4148’s and a 10k resistor and started to work the mod. And the modification went smooth as oil. The process can be seen in pictures below. I’m not going to discuss the technical detail of this mod, for this information please visit w8ji and n1eu. Oh yes, another thing I discovered was that the rig had the inrad roofing filter mod already installed, that was a nice surprise!
IF board area where the mod is going to be applyed
Connectors in the right corner removed for easier access.
Soldering diodes to connector J2001.
10k resistor soldered to ground lug and third diode soldered to TP2001.
Just became a proud owner of this renown dx-machine.