Temporary Yaesu Elevation Rotor Fix
Earlier I fried my elevation motor, and I was in need of a quick fix.
The plan is to eventually rewind the original 24VAC motor but this will take some time and materials I do not have for the time being.
The quick, non-destructive solution was to get a $7 worth 24VDC motor, and put that in to service.
All I had to do, besides the rectifier system, was to drill two new holes in the motor bracket and move the cogwheel over to the DC motor shaft.
The ZHENGKE ZGA25RP DC 24V 500RPM Micro Gear Box Motor have an unload speed at about 500 rpm, so the elevation is moving at about 1/5 of the original speed. However, this is more than sufficient when tracking the moon. The stall torque is also sufficient due to the low gearing.
I am considering to get a larger, faster and more powerful DC motor, but then I will have to ether do a non-reversal cogwheel modification or get hold of an another cogwheel that will fit.